LogFAQs > #976759744

i decided to customize the little pen cup i got from walmart, it was the same one that i had magneted to the top of the little runner shelf. a while ago i ended up just screwing it into the side of the table.

anyways, it looks like this

https://gamefaqs.gamespot.com/a/user_image/6/0/1/AAeEKDAAE9Cp.png

so i took the dimensions of it, then roughly changed it because i don't like using milimeters. i can do it, but it's not easier than inches for me. so it's very slightly larger. in mm it's an 87x87x87mm cube. that's almost 3 1/2 inches, so i just made it that.

anyways, i wanted individual slots for the nippers, and to isolate the markers and sanders. so

https://gamefaqs.gamespot.com/a/user_image/6/0/2/AAeEKDAAE9Cq.png

it would have rounded edges if i uh, knew how to do that in the particular cad software i was using.

it's printing now,

https://gamefaqs.gamespot.com/a/user_image/6/0/3/AAeEKDAAE9Cr.jpg

i was gonna use white, but uh, i happened to have a nice bright red.